Precision is the single aim at the centre of Scotia

We have the expert knowledge and experience to look after the testing, Calibration and Repair of all your specialist equipment.

The accuracy and attention to detail from our technical team – and there are over 60 of them, ready to assist – is unrivalled.

As are our 18 different dedicated laboratories which enables a wide scope of measurements and gives Scotia an unrivalled in-house capability”.

Engineering disciplines include:

PRESSURE | TEMPERATURE | ELECTRICAL | DIMENSIONAL METROLOGY | PUMPS
DEWPOINT | HUMIDITY | GAS | AIRFLOW | TORQUE | DATALOGGING
DIP TAPES FOR TANK LEVEL MEASUREMENT

Scotia can advise you on the most cost-effective solution with the knowledge and technical expertise of our teams.

Your equipment is managed through our bespoke database system, which provides reports, repair histories and calibration management routines.

A customer portal facility is also available.

Assistance

Not sure if your equipment needs simple calibration or repair? Part of our customer service is providing the advice you can trust.

If something is clearly damaged, we will consult with you on the fault and expected repair.

Beyond economic repair? We can guide you on finding the right solution for you, whether that is a like-for-like replacement, a cost-effective alternative or a rental solution.

We have a typical 3-5 day turnaround for calibration, or where time is of the essence there is our fast lane service. Here we promise to turn your job around in 24 hours, wherever physically possible.

Druck Approved Service Provider

We are the sole Druck Approved Service Provider in the UK.

We have fully trained technicians to service, repair and calibrate the extensive range of Druck instruments and calibrators.

We use only genuine Druck parts and include a traceable certified calibration and service warranty with each repair.

But we’re not just a conventional supplier. We’re here to make sure you get what you need, when you need to be right.

Scotia is accredited to ISO 9001:2015 and is a UKAS calibration laboratory 0208. We are also registered with Achilles Global Energy, Achilles UVDB, and SEQual.

So talk to our team for advice you can trust, based on years of knowledge and technical expertise.

Scotia … always measuring up to expectations

get in touch

But we’re not just a conventional supplier. We’re here to make sure you get what you need, when you need to be right.

Scotia is accredited to ISO 9001:2015 and is a UKAS calibration laboratory 0208. We are also registered with Achilles Global Energy, Achilles UVDB, and SEQual.

So talk to our team for advice you can trust, based on years of knowledge and technical expertise.

Scotia … always measuring up to expectations

get in touch

HEAD OFFICE
Campus 1 • Aberdeen Science & Technology Park •Balgownie Road • Bridge of Don • Aberdeen • AB22 8GT

Tel +44 (0)1224 222888
info@scotia-instrumentation.com

NEWCASTLE OFFICE
New York Industrial Estate • North Shields • Tyne & Wear • NE27 0QF

Tel +44 (0)191 296 3444
info@scotia-instrumentation.com

HEAD OFFICE
Campus 1 • Aberdeen Science & Technology Park • Balgownie Road • Bridge of Don • Aberdeen • AB22 8GT

Tel +44 (0)1224 222888 • info@scotia-instrumentation.com

NEWCASTLE OFFICE
New York Industrial Estate • North Shields • Tyne & Wear • NE27 0QF

Tel +44 (0)191 296 3444 • info@scotia-instrumentation.com

© 2025 Scotia Instrumentation - Scotia Instrumentation Limited - Registered in Scotland No. 74997